Questions · running the assay How to use an ELISA kit - video steps The full sandwich ELISA procedure, filmed with a Human IL-6 kit, with the written steps underneath. |
The written procedure below matches the video. If your kit uses a different format — one-step, competitive, or a different sample type — follow the manual that came with it.
1Dilution of Standards
Dilute the standard by small tubes first, then pipette the volume of 50ul from each tube to microplate well,each tube use two wells, total ten wells.
| Concentration | Standard | Preparation |
|---|
| 60 ng/L | Standard No.1 | 300μl Original Standard + 150μl Standard diluents |
| 40 ng/L | Standard No.2 | 300μl Standard No.1 + 150μl Standard diluents |
| 20 ng/L | Standard No.3 | 150μl Standard No.2 + 150μl Standard diluent |
| 10 ng/L | Standard No.4 | 150μl Standard No.3 + 150μl Standard diluent |
| 5 ng/L | Standard No.5 | 150μl Standard No.4 + 150μl Standard diluent |
2In the Microelisa stripplate, leave a well empty as blank control. In sample wells, 40μl Sample dilution buffer and 10μl sample are added (dilution factor is 5). Samples should be loaded onto the bottom without touching the well wall. Mix well with gentle shaking.
3Incubation: incubate 30 min at 37℃ after sealed with Closure plate membrane.
4Dilution: dilute the concentrated washing buffer with distilled water (30 times for 96T and
20 times for 48T).
5Washing: carefully peel off Closure plate membrane, aspirate and refill with the wash solution. Discard the wash solution after resting for 30 seconds. Repeat the washing procedure for 5 times.
6Add 50 μl HRP-Conjugate reagent to each well except the blank control well.
7Incubation as described in Step 3.
8Washing as described in Step 5.
9Coloring: Add 50 μl Chromogen Solution A and 50 μl Chromogen Solution B to each well, mix with gently shaking and incubate at 37 ℃ for 15 minutes. Please avoid light during coloring.
10Termination: add 50 μl stop solution to each well to terminate the reaction. The color in the well should change from blue to yellow.
11Read absorbance O.D. at 450nm using a Microtiter Plate Reader. The OD value of the blank control well is set as zero. Assay should be carried out within 15 minutes after adding stop solution.
| Stuck at one step? Tell us where the colour does not develop, or which wash step you are unsure about, and we will look at it with you. |
SUNLONG BIOTECH CO., LTD · Hangzhou, China ·
all contact detailsGB/T 19001-2016 / ISO 9001:2015 · NMPA medical device filing